Mk4 toyota supra cummins diesel build

By whitz
( 6 )

3 minute(s) of a 127 minute read

6-18-2021

Well finally after 6? months finally fitted the pump, 99% of smoke issues have been sorted, been a bump steer correction to try and help it, bonnet is back for final fit and finish before paint and gained a diesel leak from the top tank seal which i only found when i brimmed it full of diesel

MG is doing MG things, for some reason I'm almost through a set of rear tyres in 1200 miles been faultless thus far 

oh and i also bought this e36/lada combo off ebay 2.8 rwd na....for now updates to follow on that


7-11-2021

Little progress post, double return bent in around the turbo cutout for strength and then after this pic welds ground back and prepped for powdercoat

going through boxes and boxes to get all the correct trim clips and such out

put all gloves boxes, kick panels carpet securing panels and side pieces in hopefully for good and trimmed back some plastic to go in around the roll cage

pair of mirrors off a s1 landrover and mounts made up, left masking tape on the door a little too long and it pulled some paint off, these are all cleaned up now and off for powdercoating too 


Comments

This is my kind of build right here. Very nicely done!

Posted by Squonkwerkz Garage on 9/28/21 @ 2:07:53 AM

I bet the purists probably don't like this, but screw them! This thing looks like a blast!

Posted by stevegolf on 10/22/20 @ 11:15:40 PM

This thing is insane. Definitely not a swap I would think of doing, but it looks like it will be a blast to drive. I like the mad max look you have going too.

Posted by MPower on 10/1/20 @ 8:26:26 PM

Wow thanks for sharing!

Posted by Diggymart on 9/20/20 @ 2:50:40 PM