Mk4 toyota supra cummins diesel build

By whitz
( 6 )

2 minute(s) of a 127 minute read

2-4-2019

started to box it all in with head scratching to sus out how to fit it all in and use speaker space aswell 

had a brand new bag blow out after 1/2 a lift, these come with no warranty but there trying to get it through warranty so heres hoping 

other rear side 


3-10-2019

Just been plodding along doing bits and pieces, tunnel painted inside and under, roof lined with flash banding, rear arches fitted for good

i was going to use an mg loom but gave up after buying a donor stripping it all out and after starting that

Had all of the boot build out, glued painted and carpeted around half of it and all back in and bolted up for good

ordered a complete set of vdo gauges, oil temp + pressure, water temp, volts, boost, tach, speedo, fuel along with the senders and I'm going to wire the car from scratch, i just ned to find a suitable warning light panel


alot of money spent at demon tweeks all black face vdos

waiting on some none stock items to turn up but dash skeleton put in place trying to figure out what gauges i want in certain spots, can see the volt in place, will rework the holes on the left and put oil+ water temp in them 

booty shot, arches where a right pita to bolt on inside the car, i know it looks all color mis matched but its not and yes it moves when its fully lowered with no catching



Comments

This is my kind of build right here. Very nicely done!

Posted by Squonkwerkz Garage on 9/28/21 @ 2:07:53 AM

I bet the purists probably don't like this, but screw them! This thing looks like a blast!

Posted by stevegolf on 10/22/20 @ 11:15:40 PM

This thing is insane. Definitely not a swap I would think of doing, but it looks like it will be a blast to drive. I like the mad max look you have going too.

Posted by MPower on 10/1/20 @ 8:26:26 PM

Wow thanks for sharing!

Posted by Diggymart on 9/20/20 @ 2:50:40 PM