You must be logged in to rate content!
2 minute read
28. Lift the armrest up and remove the two bottom hinge screws.
29. Pull out the two curved plastic pieces still attached to the arm rest. Remove the two curved plastic pieces.
30. Separate the plastic lid by removing the eight screws on the inside
31. Wrap the new leather cover around the plastic lid.
32. Tape the front and back elastic edges down so they don't get in the way of the screw holes. Place the two curved plastic pieces back on their plastic pins on the lid before replacing the lid
33. Replace the wrapped plastic lid with the bottom piece. Make sure the lid fastens evenly with the leather cover over it. Insert the two curved plastic pieces into the slots and replace the two hinge screws.
Done! Since the leather arm rest is installed between the plastic pieces, the latch is a bit tougher to operate. Just take a metal key or knife and shave a very small amount of plastic off the latch and it will be easier to unlatch.
