996 Thrust Bushing DIY by Mikelly

By stevegolf
( 2 )

2 minute read

996 Thrust Bushing DIY


Compliments of Mikelly @ www.renntrack.com

I bought adjustable thrust bushings and did a search on how to instal them... Nowhere did I find one...so...

OEM Bushing, ERP Bushing and Stock Control arm:

The tools I used to press out my bushings:

You also need 18 and 21MM wrenchg/socket tools.

Heat the bushing steel sleeve (the part the rubber resides in) for about 45 seconds to a minute... Then take the hammer and the seal driver and drive the bushing up...

Installed Bushing:

It's pretty simple to align the new bushings and have them ready to install the thrust rod onto the control arms.

These units help in re-aligning the caster when you adjust for much more camber for track use.

Mike


Comments