You must be logged in to rate content!
4 minute read
2000+ SENTRA MANUAL TRANSMISSION INSTALLATION INSTRUCTIONS
1. Remove the shifter knob. If you can't do it with bare hands, try vise grips with a towel to protect the shift knob from scratching. Remove the centre trim piece that holds the shift boot in.
2. Unclip the cigarette lighter harness once the trim piece is removed
3. To remove the stock shift boot, pop it out from the clips that hold it into place.
4. You now need to remove the wire from the old, stock boot and put it into the new one. Feel around the old boot for a place where the wire is connected, it should be in the midsection on one of the longer sides. Carefully cut the fold of the leather that holds the wire to reveal the joint. Take the joint off, you will need small pliers to do that. If you do it carefully, you will not hard the old boot and will be able to keep it as a spare. After removing the joint, pull the wire out of the stock boot and slip it into the folds of the new boot.
5. To install the new boot just place it under the clips that held the stock boot into place.
6. This is what you should see at this point.
NOTE: This picture is one of the first B15 boots ever made. Soon thereafter we have discovered that a better way for mounting the top of the shift boot would be to use a ZIP-tie, and thus the boots no longer have a seam around the top. To install the new boot, please turn it inside out at this point, mount the top of the boot with a ZIP-tie and lower the trim piece. The boot will switch to the correct side by itself as the trim piece is moved down.
7. Unless you are installing the ebrake boot as well, reinstall the trim piece by sliding the back part in first and the rest will go in by itself. Make sure the back part of the cigarette lighter doesn't catch. This will make it harder to put back in. Screw the shift knob back on.
8. Remove the center console to fully expose the e-brake handle. To do that you need to remove 5 screws from console: 2 front, one under a small cover at the brake lever, 2 beneath the plastic cover at the rear by the cup holders. Then you need to pull off 2 plastic covers on each side underneath the dashboard, and the one around the cupholders, before taking the console up. After you lift the console, remove the cigarette lighter and other connections.
9. Pop out the rubber gasket surrounding the ebrake. Little buttons hold it on. We used only the 5 buttons from the rear down to hold it, because the boot won't reach reach the final 2 at the front. Turn the new boot inside out. Using the rubber as a guide, make slits about 8mm or so long corresponding to each button, about 5 mm from the edge of the boot. Use the slits to mount the boot with the buttons between the rubber gasket and the console.
10. Slide the new boot onto the e-brake handle top-first. Use a ZIP-tie to secure the top of the boot on the console.
11. Pull the console and, with it, the e-brake boot as far as it will go and re-install the center console.
