You must be logged in to rate content!
3 minute(s) of a 31 minute read
11-7-2012
Small update....................
Got some powder coating done !
Only the compressor housing remains now , I will be dropping it off on friday
I am now in the process of getting her ready fro start up , I discovered an sorted leaks in the fuel system (loose hose end fittings , mis-aligned fuel rail , LEAKING FPR diaphragm !!!! and one pin hole leak in a hose!)and engine coolant system (loose hose clamps , one gasket to make and install) . I re-routed one engine oil hose for neatness and better visual apeal , so now I need an additional 3 feet of -10 hose and the local speed shop is fresh out ! . After completing this I need to complete all my electric system checks and ECU terminations then it'll just be a matter of re-programming for the new injectors ..............
More to come !!
11-25-2012
Thanks guys ! now on to some more powder coated goodness !!!!
Dual Q blow off valves !!
As it sits now I completed all the electrical and ECU checks and all is well !
I have one length of oil -10 hose to complete then i'll be ready to start her up, should be ready by tomorrow.