An End-of-build Retrospective on my Rx7 Evo GT by gmonsen

By diyauto
( 3 )

4 minute(s) of a 280 minute read

2-5-2011

First, my guy welded 5 of the 6 runners to the plenum and is calling it a day. Tomorrow he will finish the last runner and put on the 2 end pieces. I am going to try to get him to emboss the "7" from the emblems he's making for me. He did a "G" on the first ones he showed me (below as well). The ends will be close to a semi circle on each end.


Second, I have the first pictures of the new headers that Logan Carswell (Defined Autoworks) built for me. I'll put those in the next post... 


Gordon




Here are some pictures of the first versions of the end pieces. I haven't seen the new ones.







New Headers
Its hard to figure out which to show first. I didn't have a lot of build pictures, so I think I will just show the headers off by themselves as almost finished. They will be ceramic coated a battleship grey.











2-10-2011


Haven't gotten the final pictures of the plenum yet, but have a few that show the plenum being finished. He is still working on the end cap on the plenum, because I got silly and decided to have him emboss a big "7" on the front (end) of the plenum. I probably have a picture of the wooden "7" he's using to emboss the end cap. 


Gordon


Here's the buck he's using to emboss the "7".



And, ere are a few shots of it almost completed, but some grinding and polishing to do.







2-11-2011


Here are a few pictures of the front end cap for the plenum. I had Vic put a "7" on the end cap. He should have it all welded up and then do the grinding today.


Gordon




The plenum and runners are done (minus final polish after testing). The marks from the grinding areas really need some buffing to get the full effect. The dull surface areas are like camouflage paint on a battleship. I know a lot of people are looking at the thread without commenting, but I would really like to hear any comments on the "7" I put on the end cap. Just curious...

Gordon




 



Comments

Nice job!

Posted by Diggymart on 3/13/19 @ 9:54:43 PM