You must be logged in to rate content!
4 minute(s) of a 289 minute read
3-3-2013
Yeah it must be a aftermarket top, I need to figure out what to use for the piece that attaches to the wind shield header they use some kind of plastic and its only half there! :/
Got the top sat on the jeep, I need to move my windshield back to make it fit right :/ but that means cutting and reselling the windshield spreader!
3-5-2013
The brown Santa dropped off my balancing beads and my front diff cover I am not done painting the cover yet tho!
Ok it's done being painted and is drying now!!
3-6-2013
Cover and lube locker are on and diff is full of fluid final! She is almost ready to start driving again!
I flexed it as much as I could at my house but I am faaaaaaaar from full droop. I plan getting some shock hoops and the proper length shocks after the 15th!
3-7-2013
True story, the truck being a 4x4 with the vortec sbc I am getting 15 mpg in town with it which is better that the jeep haha!
Almost for got I took the steering wheel off in prep for the new wheel!
Brown Santa dropped my corner guards off today!! I got off early so I decided to cut out the tube to fit the new corners, in case you guys missed it I ordered the rear stretch Conner guards since my tube was all ready cut out for tj flares! As you can see I didt have to cut a whole lot more out! Any ways the paint is drying on the guards and I will be installing the gurds/rear flares/ and sliders saterdays!
3-8-2013
Picked this up this morning!