You must be logged in to rate content!
1 minute read
What's up fam! On today's episode we show you how we wired in our rear light bar for our jeep wrangler JK. We purchased the light/license plate bracket on amazon (https://amzn.to/2I48v9T) and we could not be happier with the results! We connected them to our existing A pillar switch pod (https://amzn.to/39eDxYr) and the existing wiring from our rock lights.
If you enjoy our videos, please consider checking out some of our favorite JK products on amazon!
Electrical tools - https://amzn.to/2I521ra
Shrink Connectors - https://amzn.to/2I46bQa
: Smoked LED turn signal - https://amzn.to/2EQ7X67
Steel Stinger Front bumper - https://amzn.to/2WjykMA
LED tail lights - https://amzn.to/2JPBL7f
Under seat subwoofer - https://amzn.to/2JOKDK4
Red metal handles - https://amzn.to/2Wik8U1
Red shifter bezel - https://amzn.to/2HRZscH
JK light bar - https://amzn.to/2EPEOYH
Rock lights - https://amzn.to/2JPBUHP
A piller switch pod - https://amzn.to/2MoWBw2
Door hinge side step - https://amzn.to/2ENee2A
Trunk mounted table - https://amzn.to/2EOywbL
Door hinge side mirror - https://amzn.to/31pQs5a
This is the perfect set up if you are like us and you like to go camping, or overlanding. It provides a lot of light in the rear and also doubles as a license plate holder! But that wasn't all! We also opted to install some strobing third brake lights to really get the rear end to pop! We also added in some license plate lights to really get the setup to stand outSince we have installed it, we have been receiving nothing but compliments! We absolutely love the way it looks and we love how bright they make our Jeep Wrangler look! Cheers!