You must be logged in to rate content!
2 minute(s) of a 139 minute read
4-14-2011
I messed with the car a little today. I soldered some wires and drilled the hole in the trans tunnel for the engine harness.
4-21-2011
I've been slowly trying to figure out how to run the wires. I have to make some of them longer. I've been doing a lot of soldering lately. I installed the battery box in the trunk. I should have done it when I installed the fuel pump because I had to lower the tank to do it. I also ran the 1 gauge cable for the positive and negative. I've read too many stories about hot start problems when the battery isn't grounded to the block so I ran the negative cable to the engine compartment. I also mounted the solenoid. I will be adding a junction block in the fender because there were too many wires on the hot side of the solenoid. Before I could barely get the nut on. Here's a few pictures.
