American Motors Xperimental full frame by Ron S

2 minute(s) of a 140 minute read

Quarter panel molds are made, now finally on to the car. See if I can finish some of the bottom stuff, and send it to the powder coater.

3-28-2018

Got the last of the cage work finished, starting on tin work, filling in the little windows 1 at a time.

The body unbolts on this car, the chassis floor and all will be sent to the powder coater. The body may be as well, haven't decided yet. I will fill the voids in the floor with 1.75" rigid polystyrene insulation board, super light, and will make the floor flat. Then I will have some snap in carpet put on the flat part of the floor, like a boat.

I use a JD squared hydraulic/pneumatic bender, works pretty good.