The "Get Me By" MJ Truggy by cgmrdc

By diyauto
( 5 )

3 minute(s) of a 99 minute read

5-18-2014


Nick came down to help hammer out some details on the chassis this weekend, got a little distracted at the 4wp expo... Which was kinda disappointing... But non the less got quite a bit accomplished. 


Main goal for the weekend was to get the frame rails built, which was a challenge to say the least.


Made a couple small changes to the geometry, and moved the motor back and closer to center. 



Axle at full bump, 6" up, might have been able to squeeze 8" out of it but would've made things really tight. Gonna stick with 6" for now because I'm not settled on the 20" belly and may raise the rig later.




Added some more to the bend tech model. 



Got both coolant lines bent up before nick had to fly back to little rock. 


I think I've done more out of plane bending on this build than anything else I've done...



Comments

Great journey! Looks like fun getaway. Nice build.

Posted by Diggymart on 1/28/19 @ 1:42:50 PM