You must be logged in to rate content!
2 minute(s) of a 123 minute read
2-1-2010
save the hardest for last... they actually werent too bad, just a roofing hammer and the edge of the welding table later...
Driver (Mine):
Passenger (Nick's):
all thats left is to cut and reattach the little bit from the stock inner to be used and attach the side panel, but here is whats been actually fabbed, ready to clean up and prep for paint
2-7-2010
here ya go guys...
so my land lord was hangin out in the garage with me so i thought id let him contribute a little... oops... aparently following a line with a sawsall is a harder task then i thought... and so is griding the paint of around the edges... he broke one blade and destroyed the backing plate for my grinder discs... so the hole in the corner is the only thing i couldnt salvage with his hack job so i need to patch it but other than that the are ready to prep for paint.
got the hood cut for the passenger side today!
I need to trim a little in this pic so the hoods sits a little closer now.
about the same coverage as a stock flare...
and here was when i was marking it out... can you say pain in the butt...