90 yj frame swap and build up by lovett86

2 minute(s) of a 84 minute read

Havent orderd the bearings yet. But I've priced out the ones I need. There like 20 bucks a peice which is cheap. I did pick up a can of primer to go on the case and some other parts I have at work waiting for paint.

I like using tremclad. It seems to hold up well as long as you prime and paint it.

1-13-2020

I've sanded down the and cleaned up the transfer case housing and the air cleaner for the jeep. Gonna sand down the front bumper and hopefully get all of them primed tommorow.

1-18-2020

Got some primer on the transfercase.

1-19-2020

I also primed the stock air cleaner st the same time. Should have a 2nd coat on tommorow then paint. If time allows il order some bearings this week.

1-30-2020

2 coats of paint and primer on the case and air cleaner forgot to take a pic of the case.

Started replacing the shift rail seals. One is done. They have been replaced at some point but don't look like they were installed correctly. A little more corrosion on the rails then I'd like to see, but I can replace them down the road if needed.

The guy I bought the case off of was a machinist and built his own twin stick adapters. He had a hand full of jeeps at his place. I got my cj hood from him as well.