You must be logged in to rate content!
2 minute read
2000+ S2000 ARMREST COVER INSTALLATION INSTRUCTIONS
13. Take the center console and lay it upside down. Than remove the 4 screws holding the elbow pad marked by the red arrows.
14. Lay out the things you will need to attach the leather to the elbow pad. You will need glue with a brush, binder clips, scissors, and if you want to add more cushion you can add some thick cloth in between the leather cover and the elbow pad. I have also removed the old leather off of the elbow pad so that the new leather can glue properly to the plastic elbow pad. You can do this by slowly peeling the leather off.
15. Flip the leather cover over, and place the cushion cloth in the middle along with the elbow pad. Center everything and make sure that its the way you like it.
16. Add the binder clips to keep the leather from moving off center. Than brush the glue on one side of the elbow pad and attach binder clips to secure the leather to the elbow pad until the glue dries.
17. After you have put glue on all sides of the elbow pad, and attached the binder clips. this is what the elbow pad will look like. Leave binder clips attached overnight so that the glue has time to dry. Remove clips when dry. Reinstall the elbow pad back on the center console, the same way that you took it off.
