You must be logged in to rate content!
2 minute(s) of a 139 minute read
6-1-2011
I made a little more progress tonight. I mounted the vacuum tree in the drivers side fender. I also ran the hose to the booster. Then I ran the hose from the vacuum tree, through the passengers compartment, out to the passengers side fender to where the vacuum check valve is mounted.
The MAP sensor is also mounted on the passengers side.
I have most of the wiring done. I just have to straighten/tighten things up a bit. Here is the mess of wires and vacuum hoses running out the hole in the trans tunnel. I'm running everything through there. I added about 10 feet the the alt/regulator wire so it will go through there and under the intake. I also did the same to the wires for the purge solenoid and the vacuum hoses.
The only things I have left to do before I drop in the engine is bend new brake lines, because the proportioning valve will be in the drivers side fender well. Then I have to lenghten a few wires on my cooling fan harness. Hopefully the engine will be going in soon.