1dirtyZ's Conversion by 1dirtyZ

2 minute(s) of a 304 minute read

as promised here are a few more pics and some progress

I finally got the balancer on the thing , and you can tell it was on there pretty tight



here is how the balancer and brackets look on the front of the engine :



and here is how and where I plan on mounting the air to water intercooler I got for it :





I also found out the blower is leaking from one of the seals , so a seal replacement is due real soon

so the plan now is to fabricate some braces to mount the intercooler in place , then build the piping and BOV stuff, reduce the power steering pump output pressure, and swap the fuel rails, injectors, and sensors from the other engine. by then the engine should be ready to be dropped in place.

so next up on the never ending list :

- fab intercooler brackets and pipes
- swap sensors and injectors
- tighten lower A arm bolts and struts
- install new brake master and plumb brakes
- drop engine in  
- shove trans in place
- hope everything works