1dirtyZ's Conversion by 1dirtyZ

3 minute(s) of a 304 minute read

so things have been moving along nicely ( a little slow for my liking but i'm not complaining )

first off the whole interior has been ripped out , including the the original wiring harnes ( all 34,535 miles of it ) . the plan is to use a Leash panel to handle the lights, signals and other electrical stuff along with a small fuse/relay board :





the new cage is almost done, right now the rear down tubes are being welded on and after that the strut bars go in :





i also managed to mock up the bracket on the engine , i just need to get the balancer mounted on the engine and have to cog pulley bolted on to that . i also have a supercharger sprag pulley laying around that i will be using .










so the plan now is to hold off installing the engine and trans untill i have everything i need for the bracket and focus on getting the interior done first . i also want to wait a bit to see if i can get one of these :
http://www.yellowbullet.com/forum/sh...d.php?t=549765

if this goes through it will save me a ton of space as well as plumbing and fabricating to run a traditional air to water intercooler.

so next up is :

- finish welding the cage
- mount the PCM and leash panels
- wire everything up
- install dash , carpet , seats and other stuff
- finish whats needed on the new engine
- install new drivetrain
- burnouts !