How-To: Mod Euro turn signals to fit US spec bulbs and socket by volcomstone1966

3 minute read

How-To: Mod Euro turn signals to fit US spec bulbs and socket

Compliments of volcomstone1966 @ focusfanatics.com

ok this is my first little write up thing ..i thought i would do this being that i did not want to spend $15 each on euro bulb sockets

and $25 each for the plug, connector w/leads ...so that $30 for bulb sockets

and $50 for the plug,con.... stuff..so 

this saved me $80

ok so the hole on the back of the euro one is much bigger then the us one

so being that they are about the same size around ,not the hole but the outside..i used a Dremel to cut the top of the us turn sig off ,just i little below the top

once i got the "disk" off i sanded it smooth and made it look nice

after it was sanded i cleaned off the dust and spay painted them black

once they were dry but still a little tacky stuck the "disk" to the back of the euro turn sig

once i had them where i wanted, i used plastic welding to tack it then weld

them (melt them) all the way around

once i had it welded on good i sanded down the welds a little to make it look a little better..then you can paint the backs of them if you want so it looks better..

so now i have euro turn sigs to fit into my wrc bumper,that will fit 

my us spec. lights and not have to spend the extra $$$

IF YOU DONT KNOW ABOUT PLASTIC WELDING

all you realy need is a soldering gun or iron

i got a little butane one for about $20 from home depot

alll you do is preaty much melt the 2 togeter

let me know what you think

so i hope this might help someone ..

cause it saved me $80