Peugeotech's 505 V8 build (Rover 4.6L)

By diyauto
( 2 )

3 minute(s) of a 64 minute read

5-17-2014


You can make up an alloy block to replace the front x member mount which works well. The member stops twisting and wriggling with power. I have found this to also be as quiet as rubber mounts, too. If the torque tube is held fast to the x member the engine fore aft and twist is also better controlled.

I actually enjoy this craziness, now I can see light at the end of the tunnel!


6-23-2014

The small end bushes arrived today. 23mm or 0.905" from a Holden V6 Supercharged. Gudgeon pin circlips from the former as well . Only 15 more circlip grooves to cut!


6-26-2014

Purchased a matching pair of Factory Range Rover stainless headers or the 4.6. Beautifully made and with factory heat shields. Cool.

Starter to steering still a big issue , a solution will happen soon, I hope! I picked up an SD1 starter which has the solenoid facing the tarmac but with a huge Lucas shell. It should help determine a high power starter option for me though.

The rods will get the small end bushes fitted in a week or two.


1-7-2015

Splendid news! I think I've found a way through the starter issue. ( Apart from giving up). Some time spent with a flap wheel and some turning of the starter housing in the lathe has given me hope. I shall move the engine toward left hand side of the vehicle, 13mm off centre line and this 1.7kw starter by Frankenstein should be swweeet. The engine will be sitting 25mm lower than in the mock up car as well so, it's almost full steam ahead from here. I also wrecked out an SRDT 505 Monday which had a 10 bolt 3.3:1 diff centre and a BA10/5. I think that diff ratio would be a good one to keep for slightly bigger wheels and tyres.

The gearbox has 80 000kms on since rebuild by a reputable engineer. I don't need it though so it may be sold on or put under the bench for later.

The images are of the V8 engine sitting almost perfectly for a 505 on the 505 cross member and right hand drive power steer rack valve.

Images are Upside down of course, due to the effect of Equatorial Balance on the Australian Librarian's Tutorial Globe being finely balanced with a Northern Hemisphere Bias.....................................................??????????????????.!







Comments