You must be logged in to rate content!
2 minute(s) of a 241 minute read
5-20-2016
Today's job is to enlarge the spacer hole for the new throttle body, it clearly shows how much bigger is the new throttle body, i cut the throttle body flange from the intake manifold because it faces the wrong way, i neet to enlarge its hole too, and sand it smooth, that is the roughest casting i have ever seen, it's like the surface of the moon, as for the rest of the manifold i probably will make i new collector from sheet aluminium to be smooth and smaller to fit the space i have available, more to come.
5-21-2016
Today my turbo oil feed arrived, i was planning to run a hardline, but this one was at a good price and the line itself is stainless steel braided teflon, the T3 flange it has a small hole for the oil to pass in the turbo only 1mm, i plan to drill it out to 4mm , that's the size of the line, not sure is that big enough, any advice?
