Supercharged K20a2 Vtec - Race Spec by cptkirk

3 minute(s) of a 377 minute read

I might look into a stone guard for the cooler, wouldnt be too difficult to whip one up., although they should be able to withstand a certain amount of punishment from stones, else whats the point of having an air to fuild cooler if you cant put it in the air flow.

I will ask the manufacturer what their views are on it and then make a decision.

As for air flow, the wheels will help as they draw air from inside the car for the brakes, and all the air that goes through the fuel cooler is going straight into the engine bay and there will be a slight gap between diffuser and boot lip. Also the diffuser does not cover the whole of the floor area so theres plenty of places for hot air to escape.

The exhaust is getting wrapped in DEI Titanium to help with the heat also.

8-4-2009

Fuel Cooler Debris Guard

For those of you following the thread, E11evns and I were having a discussion about possible rupture of the fuel cooler so in an effort to stop this I have made a debris guard.

Fortunately I just happened to have some perforated ali sheet lying around so I cut of a corner and whipped up a guard, well it took a couple of hours after having to remove the bloody thing....

Battery Holder


Ages ago I said I was going to make a battery holder, but it fell by the wayside. So tonight I had my making stuff head on and I took the plunge and made one.

Dah dahhhh.....: