Supercharged K20a2 Vtec - Race Spec by cptkirk

2 minute(s) of a 377 minute read

Throttle Cable Mount

I had to make a slight alteration to the throttle mount to get it working sweet, my original calcs were a bit off. Anyhow - adapt and overcome......

I made use of a skateboard wheel bearing, an 8mm bolt, one standard 8mm nut, one nylock 8mm nut and two penny washers, the result is what you see below, even if I do say so myself it runs sweeeeet now..........:

Rear Diffuser

So yesterday I finished off the diffuser plug, primed it and took it my friend Stuart, who's going to whip a mould off it and then make my diffuser.

The next and rather more difficult part will be making the joining peice between the lip below the boot and the diffuser.

Anyhow - here are a couple of shots of the diffuser just before it went in the van:

Tonights progress report:

After cleaning the spray paint off of my van and my garage door that some little chav had kindly put on there ( i dont mid the garage doors that much but do not under any circumstances f*ck with a mans vehicle, I hope Karma gives the kid Hemeroids for life) I went about making progress on the car.

I spliced in the new connectors for the injectors tonight, fiddly little buggers but I got there in the end.

Re-stuck the roof lining to the roof, original sticking was not up to the job and had sagged (not of my doing), so some industrial strength double sided sticky tape and the misses giving me a hand and we had it stuck up in no time, and the roof lining....way heeeey.........

No pictures in this one......boooo.....