1380 Track Toy by minilee94

3 minute(s) of a 67 minute read

And matt in reply to the status the otherday 6k spent I'm not going to list it all as it's big spec but
£1000 on gearbox ,£350 pistons , block boring £150 new x drilled and nitrided crank with arp bolts £400 , cam kit £380 , flywheel and clutch kit £410, 3piece push rods cost me about £70 , rockers £170 , final drive £50 center strap + machining £60 , water pump £25
Dizzy £225 , coil £25 , head I got cheap all in with rebuild £200 , head bolts cost me £80 , new pot joints genuine £120 , carb set up £ 350 ,manifold £90 , new primary gear washer £35 , all new bearings in side casing , block machining £200 , thermex rad , £120 , oil cooler and hoses £80 , filter housing £50 , new manifold studs etc £20 , alternator £60 hi torque starter £160 engine and box gasket set £25 new clutch master , clutch slave , Braided hoses , brake cylinder + braided lines , med alloy crank damper pulley £160

might be more but can't think about em at the moment

Spi cooper block offset bored to 1380
Omega pistons
Arp bolts
Acl bearings bottom end
Piper 285 cam
Alloy vernier timing gear
Chilled iron followers
3 piece alloy push rods
Center main strap
37,29 valves 12g940 head (stamped 12g938)
Polished ported
11stud head ,double valve springs
Big valves
Weber 45 carb
Straight 6 inch manifold
Stainless polished manifold
Brand new x drilled nitrided , balanced crank
Med stage 2 clutch and flywheel ap bonded and riveted clutch
Straight cut gearbox , x pin diff , 3.44 final drive
11.1 compression ratio
Roller rockers
Hi torque starter
Aldon yellow distributor
Lucas gold coil
Med alloy crank damper
Turbo oil pump
Thermex alloy rad
Hi cap water pump
Electric fuel pump
Sytec fuel reg


All I can think of might of missed some out

All the company's swiftune , med etc have all said you can fit them but run the risk of them overlapping there selves or something and can fall out that's why none of the company's sell head with unleaded inserts in head with bigger valves like mine

And all engineering firms I spoke to about getting them fitted all refused to do it

And my crank I got cheap off a mate as he was building a turbo and didn't finish it and he then bought a med crank for his 7 port build
But new when I spoke to minispeed would of cost him about £500

And if your going to be redlining like that fit the med crank , nitrided x drilled , wedged crank about £495

2-27-2015

Finally got some proper miglias cheap aswell :)

Drove the mini ain't the otherday with abit of clear road and does it go ---- yes it flys really didn't think it was going to be that quick