Wide Ratio Gearbox And 1380 Engine Build by AndyMiniMad

By diyauto
( 2 )

4 minute(s) of a 171 minute read

11-23-2011

Was down at the workshop this afty...and the block is bored, the cam bearings are in, the pistons are fitted onto the rods and the gearbox case has been properly cleaned...But the gudgeon pins are a bit tight so they need to be refitted, after a little adjustment they should be fine. the gearbox case still needs a quick skim on the idler face.. Should get it all back on friday...Woo Hoo..cant wait to start building engines and gearboxes again...I love it.


11-24-2011

Look what the posty just brung!!!



Posted Image



Its my new Flanges....they are very dirty....no one likes a dirty flange!! so im off out to the garage to give my flanges a rub...



Some where in Aberdeenshire Mini360 is giggling like a girl, and he wont know why!! unless he reads this of course..its like a magnet to him....FLANGE FLANGE!!



Oh, something else came home today...its in the back of the van!! pictures later once ive rubbed me flange!!


11-24-2011

Yes I was very vigerous....and then I just took the grinder out..lol..



So after a couple of hours flange rubbing I got one to look like this..



Posted Image



Posted Image



A bit of paint on the exposed parts and it now looks like this..



Posted Image



And then Out of the van came this...Woo Hoo!!



Posted Image



Posted Image



Posted Image



And due to the need for power....RED!!



Posted Image



Tomorrow ill do the other flange and paint the other side of the block...Then its time to start the build...


11-26-2011

Pistons...shiny pistons...



Posted Image



What do you think..Silver head on a red block?



Posted Image



Hope I can remember where all these bits go..



Posted Image


It was £250..Rebore to 73.5mm new cam bearings pressed in, Pistons fitted to rods which were end over end balanced. Head skimed 20 thou. gearbox case has been cleaned and skimed at the transfer gear face. And new idler bearing has been fitted..I think thats the lot.

I could have got it done a tad cheeper but would have had postage costs...The workshop I use are local to me and they have done work for me before...I trust them, which counts for a lot.


11-28-2011

Ive started the engine build and its coming along quite well. the crank and pistons are all fitted and it turns nice and smooth..end float on the crank is only 0.00197" and thats a bit tight. but the thrusts were brand new and 0.002"- 0.004" is recomended...Its not that far off so im going to leave it. If the crank was tight to turn then I would have been more concerned, but I can turn it easily with two fingers...

Posted Image

0.05mm...or 0.00197" in old money.

Posted Image

All in and torqued down.

Posted Image

Pistons all fitted..



Comments

Nice details!

Posted by Diggymart on 5/20/20 @ 6:21:55 PM