You must be logged in to rate content!
3 minute(s) of a 66 minute read
2-9-2013
been busy today,we started off by sanding off all the weld through primer showing in the non welded areas primer off the rear vallence and any surface rust that was beginning to show.
also keyed up the e coating on the wheel arches
once this was ready it was time to blow it all off and clean all over with panel degreaser.
this is the acid etch we are using
and beginning to paint
the finished product
the when it was dry we stored it out of the way.
i also quickly welded on the spare wheel bracket on to the heel board.
next it was the turn of the floor pan.
it was quite easy to clean up as it still had its original underseal on it
next the areas we we couldnt quite get all the light rust out with sanding we coated with Kurust.
once the kurust had dried and we had blown it off and degreased it it was the floorpans turn for some etch primer.
thats all for today more tommorow.