Vanny My 1961 Mini Van by minbin 69

By diyauto
( 4 )

2 minute(s) of a 74 minute read

4-6-2013

Gonna wait till i get the pistons out before i start on them..but the lack of a flywheel puller is holding that up for now..
as for the valves i did them in place (lack of compression spring tool) and after your coment about the faces i left the old head gasket on just for a bit of protection against drill slips :D

Posted Image

look a bit better...is that how they should look or do i need to keep going?


4-7-2013

ok so today utter stupidity and an inablity to wait for anything got the better of me :shy:
the fact is i ordered a flywheel puller last night off ebay..and yes some of you will know where this is heading... :withstupid:
my mate said hit it from behind through the starter motor hole..keep turning it and it'll come off..then some idoit managed to clip the housing and take a chunk out of it... >_< :!: yes the air turned blue.....

So now my Question is are the flywheel housings the same for the different engine sizes? cause i have one that came off either a 998 or 1098 engine anybody know?



Comments

Wow nice!

Posted by Diggymart on 4/19/19 @ 1:10:11 PM