You must be logged in to rate content!
2 minute(s) of a 203 minute read
12-20-2012
I built the axle end mounts for the coil overs... I cut apart the stock leaf spring mounts
I cut some steel to fit the axle tube
I then cut the bushing hole out so I could reuse the poly bushings
Then welded it together and assembled it to the shock. I will remove it to weld to the axle housing .... maybe next week... MERRY CHRISTMAS everybody!
1-30-2013
Sorry, no updates. I broke some ribs dirtbike racing before x-mas. When I felt better, I found an Evo dirtbike to rebuild for racing. It is done, so back to the MG next week.
Comments
This thread was donated to our website to be preserved. If you want to message the author, please click the source link to contact.
Posted by diyauto on 8/25/21 @ 1:32:42 PM
This is a great build with so much time and effort put into recording in words and pictures. Can you help me with this question please, Is the top arm inner pivot point is in the same place as the original pivot point? Regards Davy
Posted by DavyF on 4/16/20 @ 6:44:51 PM