You must be logged in to rate content!
2 minute(s) of a 203 minute read
8-1-2012
Looking good! I lowered my ride height adjusters all the way. My calculations were spot on. It is too low with them all the way down, too high with it all the way up. Adjustability at its finest
You can see the strut towers I built through the empty headlight holes:
Next up is buying and installing the correct springs. With the current springs, there is negligible static sag. When the correct springs are installed and the rest of the car, weight wise is there, I will have to raise the ride height again:
Comments
This thread was donated to our website to be preserved. If you want to message the author, please click the source link to contact.
Posted by diyauto on 8/25/21 @ 1:32:42 PM
This is a great build with so much time and effort put into recording in words and pictures. Can you help me with this question please, Is the top arm inner pivot point is in the same place as the original pivot point? Regards Davy
Posted by DavyF on 4/16/20 @ 6:44:51 PM