American Motors Xperimental full frame by Ron S

By diyauto
( 6 )

3 minute(s) of a 140 minute read

12-23-2011


The whole cage is 1 5/8" chromoly, if I remember correctly SCCA requires 1 3/4", so no its not built specifically for SCCA. I designed it to stiffen the car without adding too much weight, and for head room, vision, saftey, and ease getting in and out of the car. This is a driver, built to run in the A.S.S. (LOL). This will definitly be one of the safest cars in the series, and once I close everything up and put carpet(yes carpet) on the floor, it won't look near as busy.


The fuel tank has worried me since I dreamed up this build, I really wasn't sure how tight the rear compartment was going to be until the watts bars went in, now that they are in I can get it figured out. I think I can buy a poly tank from Speedway that has no holes in it yet, and stand it up rather then laying it flat, or build one out of aluminum. Either way I will have to fab the internal fuel pump and trough like I did in the Mustang.


12-24-2011

The more I look at these pics my buddy Mark took, the more tempted I am to finish the flares and floor, bolt the car back together, leaving it in its original faded baby sh*t yellow paint. If only I could figure a way to fade out the quarters and fenders to match.

AMC AMX

AMC AMX


12-26-2011

I'm loving how smooth the bottom will be

torque arm


You got the mental part right. It will run along the torque arm on the drivers side, and alond the driveshaft on the other, in 3", go up and over the rear, and exit behind the rear wheel. Its kind of nice I get to do that from above before the floors are installed. I think the trans mount and exhaust will be the next thing as soon as the cage is done.


Yeah Andrew its the torque arm/trans mount so it kind of has to come out. I was a little worried about the strain of the torque arm, so that crossmember of made of 3/16", and the bolt together section is extra beefy, I need to study at weight watchers!!!!


Should all be tucked up pretty tight, just started the X bracing behind the watts, don't know why, but I really love the X's in a cage, makes it super strong and it just looks sexy.

AMC AMX tube frame



Comments

Very cool!

Posted by bl_steel on 1/26/21 @ 1:24:52 PM

This is amazing !

Posted by Diggymart on 3/10/20 @ 7:09:18 PM