You must be logged in to rate content!
2 minute(s) of a 42 minute read
12-5-2012
I drove the car to the vinyl shop this morning so that they can finish their video; hopefully will be out soon..
Then I got to the office and I could not resist…
12-12-2012
As the bonnet was arching on the middle in between the two pins and vibrating at higher speeds 150 mph+ I decided to add a bracket that would support flat the middle section. I built the bracket then painted it in flat black and last added a foam gasket so that absorbs the vibration of the bonnet; to avoid the exposure of it I cut open the rear engine bay cover and slide the bracket in there.