You must be logged in to rate content!
2 minute read
Engine start button
Compliments of SupraManAG @ http://acurazine.com
3-14-2009
Writeup:
I purchased a S2000 button start kit from ebay. Kit included button, wiring, wiring instructions and relay. Procedure was fairly simple. You will need a dremmel tool, splicing abd crimping tools. I placed my button where the cigarete lighter was. I had to carefully bore the opening to fit the button. Always do a bit at a time because you can never put back that which you have cut away. Once fitment have been delt with connecting the wires is a very easy task. Connect the black ground wire to a nice ground. I used the ground on the left of the audio unit. Its on the outside of the panel. You then have two pins to connect as per diagram. 87 and 30. 30 is out to starter wire (12V when key on III only) and 87 is to a ignition source (12v when key is on II and III).
If you procede to remove the panels covering your key/ingition control you will find a harness with some unusually think wires. Its located directly under your steeringwheel. The wires you need are blk/white and blk/yellow. Black/white will be your pin 30 starter signal and blk/yellow will be your ignition (constant 12v) source. Everything worked out great for me. Button works like a charm. I spliced my wiring and did not fully cut it to keep III function for my automatic start function on my alarm.
