You must be logged in to rate content!
2 minute(s) of a 132 minute read
11-30-2015
I finally found some time to work on it a bit more. Juggling a few projects again.. Made some decent progress I think.
this is pretty much where its going to sit, I forgot my digital level so im not positive as far as height/control arm angle goes but its with in 1/2" up and down I think. just need to verify it and get it 100% now. beefed up the modified factory subframe a little so I can cut out notches for the control arms to pivot.
finding center. hard to see the yellow center line, but I guessed when I clamped the subframe down, it was less than 1/4" off center! pretty damn good if you ask me!! need to verify my measurements a few times before its set it stone, and get it 100% perfect. front to back is also within 1/8" to 1/4" of being perfect. little bit more tweaking.
fits pretty decent, well better than expected. definitely will need to get cut for clearance but not as much as I was expecting.
Comments
Will be cool ??
Posted by Diggymart on 1/24/21 @ 2:15:42 PM
Any updates?
Posted by diyauto on 1/11/21 @ 7:46:35 PM
Thanks!
Posted by BerettaLS on 11/13/20 @ 3:47:30 AM
Impressive! Going to leave a lot of unsuspecting people in the dust with this thing
Posted by miatamatt on 11/6/20 @ 7:11:45 PM
Crazy in the best way possible.
Posted by MPower on 10/31/20 @ 3:11:38 AM
This thing is wild! That V8 fits in there nicely. Will be the ultimate sleeper.
Posted by stevegolf on 10/28/20 @ 11:34:27 PM
Any updates ?
Posted by Diggymart on 4/20/23 @ 7:08:14 PM