1970 RS Project by aps63

2 minute(s) of a 120 minute read

Pulled the axles out to start mocking up the Kore-3 brakes today. The stock axles flanges have to machined down to fit the rotors.
The axles looked a little worn so a quick call to Moser and they are making axles to fit my application including the screw in ARP 1/2 studs.
Also ordered a new set of bearings while I'm at it. They said I will have it by friday, so hopefully the back will be done this weekend.

9-11-2012

I had read the Kore 3 directions twice and just read them a third time and just realized that I forgot to order one little but very important part.
The parking brake clevis to attach the Lokar parking brake cable to the Kore-3 actuator. Quick call and the part is on the way.

9-12-2012

I used the same paint (cast coat iron) that I used under the hood.
It's high temp and very durable. The black part, I tried (without success) several differant kinds of paint. Including paint for plactic and rubber. Each time it peeled off or bubbled as soon as I squeezed the boot.
I finally used the same bedliner that I have used on the underneath of the body and all the suspension parts. It gives it a low gloss look and a slight krinkle finish. Hard to see in the pictures but it really looks great. Time will tell.