70 XR7 by haynmerc

2 minute(s) of a 61 minute read

Here are the steering column mods for erkthejerk73.

Remove the column lock shaft by removing a half inch bolt near the top of column. Rotate cover below key util you see bolt in hole.

Cut 1" off bottom of column (for better angle to R&P). Layout, cut shaft and weld in double D shaft.

Install shaft, center support bearing and lock retainer. Weld bearing to column and you're done...not hard at all...the instructions that come with kit are very good.

1-5-2014

Today I made and finished welding in a gas pedal mount. Totally made it up myself, it looks weird but provides a flat surface for the electronic gas pedal to bolt on. The Coyote set up is electronic, no cables.

It has to conform to firewall and floor, yet make sure the gas pedal is actually in same area as stock factory pedal. I welded nuts behind so new pedal can be an easy bolt in.

Here it's welded to floor

Final bolted in