70 XR7 by haynmerc

By diyauto
( 4 )

2 minute(s) of a 61 minute read

1-4-2014


Here are the steering column mods for erkthejerk73.


Image 


Remove the column lock shaft by removing a half inch bolt near the top of column. Rotate cover below key util you see bolt in hole.


Image


Cut 1" off bottom of column (for better angle to R&P). Layout, cut shaft and weld in double D shaft.


Image 


Install shaft, center support bearing and lock retainer. Weld bearing to column and you're done...not hard at all...the instructions that come with kit are very good.


1-5-2014

Today I made and finished welding in a gas pedal mount. Totally made it up myself, it looks weird but provides a flat surface for the electronic gas pedal to bolt on. The Coyote set up is electronic, no cables.


Image 


It has to conform to firewall and floor, yet make sure the gas pedal is actually in same area as stock factory pedal. I welded nuts behind so new pedal can be an easy bolt in.


Image


Here it's welded to floor


Image


Final bolted in



Comments

Great build and details! ?

Posted by Diggymart on 12/3/20 @ 8:27:45 PM