Badev0's Build part 2 - Built 2.0/FF 6266 by badev0

2 minute(s) of a 206 minute read

Tom and I and ready to tune it for power. I've been pretty busy through the Holiday's so we will probably do that this week. 

Grimmspeed 3 port mounted:

WG is going to be dumped out the hood vent. I still need to slash cut it so its flush with the top grill. It will sit directly under with less than a MM of clearance. I don't want it sticking out the hood. 

The last thing to do is make this this into 2 pieces or possibly 1. Below was only used for mock up and to get the car on the road. Pretty much just threw crap together I had laying around the garage...

Before spring the catch can setup with be ditched and i'll have a new setup that mounts behind the driver side headlight. I will also be venting the block from the balance shaft inspection hole.

1-9-2013

Got the lower IC pipe finished. All that's left to do is slash cut the dump tube lol. 

.065" wall aluminum 

DIY bead rolled the ends with a $2.50 2.5" muffler clamp and a washer + vice grip...

Much better!!!

For those interesting in the bead rolling:

http://www.dsmtuners.com/forums/cust...bead-tool.html