Antilag_200 attempts a Wire Tucking Project: PRESHOOTOUT BUILD by antilag_200

2 minute(s) of a 128 minute read

The car is under lock and key 

Got some of parts back from the annodizer yesterday 

the catch can

and here it is installed , 

Dan you asked about the lines coming from the block it is kind of difficult to see in this picture, but the line that has the black heat sheeting on it , is the one coming from the block

On the dip stick welded up a fitting to it and then simply attach your fittings and lines of choice, in my case it was pro-lite line with earls -6 fittings

Picture of the lines of the head can be found at the link below: The system of the head is virtually the same from what I did in 2008

http://forums.evolutionm.net/evo-eng...an-system.html

Coil on plug plate

and the center plate is for my ignition box

Jeremy was working on the idle tune, and the next phase will be to dial the fuel, as it is running a little rich down low. More to come