You must be logged in to rate content!
2 minute(s) of a 9 minute read
11-7-2011
This is from a client's car with the GFX rear add-on:
6-7-2012
PM's replied!
For installing the diffuser, the best process is to first center the diffuser (having a friend helps out and also if you have a lift it will make things easier)
Use a piece of small masking tape to mark the center since this it very important. The diffuser should line up with the outer edge of the bumper but NOT protrude past it if you are standing over the rear bumper. So in other words if you stand looking straight down, you should not see the end of the diffuser.
Once you are sure it's centered, only install the middle screw and slowly work your way out. By only attached the middle screw, it will give you a chance to pivot/swing the piece until it's even on both sides. Do NOT start with the outermost screws.
Hope this tidbit helps!
5-7-2013
Found this really stunning picture of the red IS-F, color is really growing on me!
9-17-2014
At Magnusson Lexus car show, diffuser without the wrap looks clean too!