JDM aristo XENON retro PART 1 by lexus4jess

By diyauto
( 2 )

3 minute read

JDM aristo XENON retro PART 1


Compliments of lexus4jess @ www.clublexus.com

7-23-2004


I will be doing a xenon S2000 retrofit on a set on jdm headlight for a GS300.part 1 ,we will be removing the orange turn signal reflectors.


pay close attention students.


Macintosh HD:Users:nickbalistreri:Desktop:ap1010012.jpg


first we need to remove the lens from the housing.


you can do two things.


1.Use a heat gun.


2.Put the headlight in the oven.This requires you to pre-heat the over at 200 degress.once it's hot ,you will turn off the oven,put the headlights for about 2 minutes.{use leather glove,cuz it's hot.}seperate the len and housing.done.


Macintosh HD:Users:nickbalistreri:Desktop:ap1010015.jpg


Now you can remove the orange reflector.There is one small philips screw holding the inter trim.Unscrew it.The orange reflector is glued to the trim.You can pop it off with a flat head screw driver.


Macintosh HD:Users:nickbalistreri:Desktop:ap1010021.jpg


pic 2 remove orange lens.


Macintosh HD:Users:nickbalistreri:Desktop:ap1010023.jpg


install the trim back in the lens,put the screww back and your done.


Macintosh HD:Users:nickbalistreri:Desktop:ap1010025.jpg


part two will cover the hid retro of the S2000 projectors.hehe 


hope you guys can understand this.


Need to make brackets to mount on the OEM location.This way you can aim the projector with aimming screws.NO GLUE WILL BE USED ON THIS XENON RETROFIT.


Macintosh HD:Users:nickbalistreri:Desktop:ap1010029.jpg


JDM -S2000.


Macintosh HD:Users:nickbalistreri:Desktop:ap1010034.jpg


JUST PAINTED MY SC430 PROJECTOR,that I will install in my fogs.hehewill post pic's later.




Comments