SBB sheetmetal intake and more… by 87GN@Tahoe

2 minute(s) of a 55 minute read

Derek,

Thanks for the kind words! It may still be a bit before I burn rubber in anger! I am going to be working for two fire departments this summer.. Fallen Leaf, and I just got picked up by Cal Fire... Cal Fire will have the priority though! So, finding time will be a trial for sure! It's definitely closer than a couple years ago!

I got the 6" small journal rods, little ends have been narrowed already, and the machinist found that SBC bearings will work with no further mods!

4-18-2016

4-22-2016

Not my wagon, NOR a SBB... but it was a Buick and FUN!:

This car is for sale. With all parts as seen plus lots more. Haven't made any progress since the last posts.

$12,000
Located in Sacramento, California. (530)318-9528

-fully machined 300 short block with speedpro 3.8litre forged pistons hung on 6" chevy rods, stock crank neutral balanced with a ton of mallory metal. Total seal rings. .050" mls headgaskets

-landover Discovery front cover for mockup which is what the crossover was built for.

-posi carrier for 8.2" BOP rear.

-coilovers.

-rear disc brake kit.

-bunch of MSD ignition stuff.

-ton of -6an, -10an fittings, hose, and aluminium fuel line and lots more.

-BOP TH350 trans that was going to get a performance rebuild but never happened.

-brand new gas tank that was sumped for the aeromotive A1000 fuel pump pickup.

Check out the thread and see if you want it. Not going to separate