SBB sheetmetal intake and more… by 87GN@Tahoe

2 minute(s) of a 55 minute read

3-12-2012

Currently has a .81 A/R exhaust housing on it... I also have a .96 housing for when I step up the displacement.

3-18-2012

Just got my Accel Gen7 setup in the mail... Along with over 18" of snow, so no install progress for at least a few days...

Just got my Accel Gen7 setup in the mail... Along with over 18" of snow, so no install progress for at least a few days...

10-31-2012

A bit slow on updates...

Last Memorial day my buddy who's been doing the welding, Ansel White http://www.anselwhite.com/ , took his Ducatti for a spin to Emerald Bay and back. Along the way he went off the road and smashed his head into a rock. He cracked his helmet upon impact, causing some serious trauma to his brain, and he also broke his clavical. 

He was flown by Care Flight to Reno. The flight nurses (one of whom is one of my good friend's wife) did not think he was going to make it. 

With the might of his stubbornness and prayers from friends and the community he pulled through. He spent quite a while in a medically induced coma, then weeks of physical therapy ensued. 

He's home now, and recovered for the most part. We are all very happy to have him back!

He just recently took back up the tig torch and finished the intake;

I've picked up more parts in the mean time as well. Just a short post for now, more later.