Yet another, BMW E-36 LSx conversion... by BRAAPZ

By diyauto
( 2 )

2 minute(s) of a 105 minute read

10-30-2010

Short version, fired up the engine today! WOOHOO!


Long version.
Built a DIY LSx engine oil primer, (air actuated piston forces 4 qt’s of fresh oil in to the engine oil galleys via the port above the oil filter), worked out perfect pressurizing the oil galleys with fresh oil, as well back filling to the pump. Just cranking the engine over on the starter with the coils/injectors disabled works fine, I wanted fresh oil to the bearing before spinning the crank.
After a few electrical checks to verify wring was correct, no back feeds were going to keep the start engaged, pressurized the fuel system, etc. Then bumped the starter and the engine immediately came to life on all 8 cylinders, WOO HOO!

Here are some pics of the oil system primer and video of the start up.




Flames!



As a gag we clamped an old dead Turbo onto one of the exhaust Mani’s, it would barely spin, (boost gauge sitting on the intake)




Comments

Nice build

Posted by Diggymart on 12/19/19 @ 9:47:32 PM