Project Fredybender V2.1 : NA with an attitude for the track by fredybender

2 minute(s) of a 234 minute read

Not much posting, but working at a steady pace.

Made some bumper cover mounts, so the front bumper cover sits real tucked in. I also wanted to have a permanent tow-bar attachment, so I combined them both, in one fabrication. 

I mocked up where the ignition module (Megajolt Jr v3) and the painless fuse boxes would go; decided to have them nicely tucked away in the glove compartment.

I also worked on the dash & figuring out circuits for everything; I am making everything new, no gremlins allowed. Hazards running with appropriate diodes on the flasher circuit, shift light (LED with resistance) right in my face! etc...

You can see in the picture below that spaghetti has begun!

Engine bay: 

Fuel pump & circuitry: Check

Coil pack wiring & fitment: Check

Custom fabbed wires (16V front ends with Ford back end for EDIS4 coil pack): Check

EDIS4 module wired, routed, and installed including all shielded wires, etc... : Check

VR sensor install & wired: Check

Starter, alternator, & engine grounds & wires: Check

Brake light circuit: Check

Here we see the empty space that needs to be occupied by a Rad... I have fabbed & welded my alloy rad once, and still had clearance problems; I will be attacking this shortly...

Rear of the car wiring almost finished

Here we can see my front end pretty much the way it should stay...