You must be logged in to rate content!
2 minute(s) of a 127 minute read
8-16-2020
post time, now shows to go to so haven't bothered to do much, its been that hot with the car sat outside ive had a airline blow out twice under the big rear window
loads of sound proofing in ziplock bags to stop the foam holding water
id rather have a drinks holder then an ashtray so made out of of a a new oil filter housing foam strips to hold and fibreglass while also filling in the selector gap
just needs paint now
did work under the one arch seals etc stuck arch and rock slider on (for good hopefully)
need to do other wing then front bumper trim before i can final fit front arch
start of box base
pair made up 32 screws each need to possibly add a central brace
two side pieces done and centre needs to be redone didnt have enough to carpet in one piece so did a temp job so make sure it fits fine
some audio
rear pic, see a mdf piece on the left thinking of mounting speakers and subs there
Comments
I bet the purists probably don't like this, but screw them! This thing looks like a blast!
Posted by stevegolf on 10/22/20 @ 11:15:40 PM
This thing is insane. Definitely not a swap I would think of doing, but it looks like it will be a blast to drive. I like the mad max look you have going too.
Posted by MPower on 10/1/20 @ 8:26:26 PM
Wow thanks for sharing!
Posted by Diggymart on 9/20/20 @ 2:50:40 PM
This is my kind of build right here. Very nicely done!
Posted by Squonkwerkz Garage on 9/28/21 @ 2:07:53 AM