Mk4 toyota supra cummins diesel build

2 minute(s) of a 127 minute read

windscreen blower vent  in place about 6 screws holding it in, was toight

face vent done the same and in place too, had to take tabs off the back of the relay to get close to fitting side ducting 

number plate tilts up for access 

banding up the seperate loom sections to tidy it up, radio power/earth with Dab and mic plug, hazard switch and dash loom plug done there

around 2.5x1ft of inch thick sound proofing foam glued and wedged into that corner of the dash 

alot of messing about in and out about 3 times to sort a few issues all very tight fit, i might just end up putting a few small scews in to hold it firm, sound proofed across top and on the right under dash 

had to make  a mounting block for arm rest out of wood and all filled with sound proofing around the same around here as left in dash, will have to buy a few more meters of it, inside armrest is a cig lighter plug, radio usb and airride controller wire so all hidden

around 75mm of sound proofing there, i stuck in more after, it compresses well so helps keep a small amount of pressure in panels to stop the dredded sqeak