Mk4 toyota supra cummins diesel build

By whitz
( 6 )

2 minute(s) of a 127 minute read

7-25-2019

unfortunately i have a face for radio and a voice for silent film



Propshaft back from balancing, painted up and new bolts etc and put on...for good hopefully

going through those horrible jobs, bare rose joints will fail and mot and not last too long so covered in grease and ball joint rubber boots stuck on to cover them all, 6 per side total they fit pretty well

can barely see them

heat shields to help deal with the turbo trying to cook everything, exhaust downpipe and lower piece wrapped and 3 shields currently in place, not sure if i will do another one across the bulkhead or forwards , not the prettiest due to bends but will work

unfolded the bare sheet

will take a pic when I'm under the car as its in place, covers part of the floor but mainly the underside of the starter motor, 0.9mm zintec plate to help keep its shape over time, folded over edges to help it keep its shape well without it

this one ontop of the turbo, 

even the exhaust is going matt black, ran out of VHT 2 cans not enough to do the whole system



Comments

This is my kind of build right here. Very nicely done!

Posted by Squonkwerkz Garage on 9/28/21 @ 2:07:53 AM

I bet the purists probably don't like this, but screw them! This thing looks like a blast!

Posted by stevegolf on 10/22/20 @ 11:15:40 PM

This thing is insane. Definitely not a swap I would think of doing, but it looks like it will be a blast to drive. I like the mad max look you have going too.

Posted by MPower on 10/1/20 @ 8:26:26 PM

Wow thanks for sharing!

Posted by Diggymart on 9/20/20 @ 2:50:40 PM