You must be logged in to rate content!
3 minute read
Panhard bar / lateral bar DIY
Compliments of marley4us @ club4ag.com
2-26-2013
Got my parts in for my DIY Panhard bar / lateral done.
-2458K182 Ball Joint Rod End 3/4"-16 Lh (you just need one of these) $17.36 each Mcmaster.com
-2458K181 Ball Joint Rod End 3/4"-16 Rh (you see a trend starting ) $17.36 each Mcmaster.com
-6381K121 Bronze 3/4"-1/2" bushing (you'll just need one) $1.64 each Mcmaster.com
-91034134-27 (27")ALUM TUBE FOR 3/4" HEIMS (you'll need just one) $14.95 each Speedwaymotors.com
**These are your choice since it's just stuff you can get at your local hardware store and probably be cheaper but I'll list it up anyways
-1756047-LH JAM NUTS 3/4", STEEL 6/PACK (you just need one per side) $3.95 Speedwaymotors.com
-1756047-RH JAM NUTS 3/4", STEEL 6/PACK (ditto^^) $3.95 Speedwaymotors.com
I put the fitting on my drill and used some sand paper to get a perfect fit, took less then a min to do 
done
if you are using a celica suprarearend, you need to extend the bar another 1/2 inchs
I also finally finished the Panhard bar/ lateral bar. So the DIY set up does not fit a celica supra rearend just FYI for anyone else wanting to do this. I had to order a extra extension from K and H an local store here. K and H metals supply part number 917020044 3/4-16 alloy linkage adjuster Then grind down the metal around the bolt "it had a little ring around it" so I could get the bar to slip over it.
