DIY 4 Link by marley4us

By stevegolf
( 1 )

2 minute read

DIY 4 Link


Compliments of marley4us @ www.club4ag.com

I found this on 86garage.com I think its the same part numbers as club4ags old one... hope so.

"Ok so after posting in the drift setup thread I went digging for all of the info on my four link. Enjoy!

You will need these parts to make the four link. I ordered them from speedway motors and mccaster-carr. I bought all of the washers and nuts from them even though they cost a little more so if you can find them for less go for it.

parts from speedwaymotors.com for the four link

2 91034158-15 Aluminum Tie Rod Sleeve, 5/8", 15" $7.95 EA

2 91034158-7 Aluminum Tie Rod Sleeve, 5/8", 7" $7.95 EA

1 1756048-LH JAM NUTS 5/8", STEEL 6/PACK $3.45 EA

1 1756048-RH JAM NUTS 5/8", STEEL 6/PACK $3.45 EA

Parts From mcmaster-carr.com

4 2458K171 CARBON-FIBER RACE BALL JOINT ROD END, 5/8"-18 RH MALE SHANK, 7400 POUND LOAD CAPACITY $13.72 EA

4 2458K172 CARBON-FIBER RACE BALL JOINT ROD END, 5/8"-18 LH MALE SHANK, 7400 POUND LOAD CAPACITY $13.72 EA

8 6381K47 ALLOY 932 (SAE 660) BRONZE SLEEVE BEARING, FOR 1/2" SHAFT DIAMETER, 5/8" OD, 3/4" LENGTH 1.24 EA

2 packs 91166A290 METRIC DIN 125 ZINC-PLATED STEEL FLAT WASHER, M12 SCREW SIZE, 13MM ID, 24MM OD, 2.3-2.7MM THICK $6.25 EA

If you build it this way the total comes to around $170 $150 without nuts and washers"


Comments