You must be logged in to rate content!
2 minute(s) of a 22 minute read
10-27-2020
I finish the b pillar details so that the new rear quarter panel has a place to attach. I attempt to bend 1/4" steel rod by hand several ways.
10-28-2020
In this video I reuse the original short front door outer sheet metal to make the new wide rear fender fro the Impreza.
10-29-2020
In this video I make a custom inner fender/ wheel tub that starts as a piece of flat sheet metal.
10-30-2020
In this video I make the mid section of the new rear fender for the Subaru Impreza 22b inspired hatchback.
11-1-2020
Comments
This is going to look sick, always wondered why Subaru didn’t make a true hatchback.
Posted by miatamatt on 10/28/20 @ 11:48:40 PM
Man this is a ton of work, lots of chances to show off your skills. I like how you go into each section of the bodywork. You’d think doing something like this would t be too hard but there’s a lot of decisions to make with each panel.
Posted by MPower on 10/31/20 @ 3:07:24 AM